Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Embroidering using
the Link function
First, use the embroidery editing software to create
the embroidery pattern to be sent to the embroidery
machine.
● Only embroidery data in the PES format
(.pes) can be embroidered using the Link
function.
● The Link function cannot be used with
large-size (split) embroidery patterns or
embroidery patterns for the jumbo frame
(optional).
● Attach to the embroidery machine the
embroidery frame for the size of the
pattern to be sent.
1
Touch
screen.
2
Touch
When the following message appears,
touch
Note
, and then touch
to display page 5/5 of the settings
to enable the Link function.
.
Sending Embroidery Patterns From a Computer to the Machine (Link Function) 175
3
Turn off the machine.
4
Use the included USB cable to connect the
embroidery machine to the computer.
• When connecting the embroidery machine
to the computer, be sure to use the
included USB cord clamps. For details on
using the USB cord clamps, refer to
page 170.
and
Turn on the machine.
5
6
Using the embroidery editing software
provided with the Link function, such as
Palette 9 or later from a computer, will
allow you to send the embroidery pattern(s)
to the machine in the Link mode.
5
Advertisement
Table of Contents
Troubleshooting
