Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
4
As described in steps
the protective cap from the rear screw hole
on the side of the machine, and then insert
an opened USB cord clamp.
5
Check that the USB cord clamps have been
firmly inserted into the front and rear screw
holes on the side of the machine.
• If the USB cord clamps are not firmly
inserted into the screw holes, they are not
correctly installed. Firmly insert the cord
clamps into the screw holes.
6
Pass the USB cable through the front USB
cord clamp, and then close the clamp to
secure the cable.
● When passing the USB cable through the
clamp, do not insert it with excessive
force; otherwise, the clamp may break.
1
through
Note
3
, remove
7
Using the same operation described in step
5
cord clamp.
8
Arrange the USB cable between the USB
cord clamps so that the cable does not
interfere with the operation of the machine.
● Store the protective caps, which were
, secure the USB cable with the rear USB
Memo
1
removed in step
, in the included
accessory case so they will not be lost.
Selecting an Embroidery Pattern 171
5
Advertisement
Table of Contents
Troubleshooting
