Table of Contents
Advertisement
SELECTING/EDITING/SAVING PATTERNS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Concerning optional embroidery cards
•
Do not disassemble or alter the embroidery cards.
•
Do not forcefully bend, drop, scratch or place heavy objects on top of the embroidery cards.
•
Do not allow the embroidery cards to become wet, such as with water, solvents, drinks or
any other liquids.
•
Do not use or store the embroidery cards in a location exposed to strong static electricity or
electrical interference.
•
Do not use or store embroidery cards in locations exposed to vibrations or impacts, direct
sunlight, extreme dust (or lint), high temperatures, high humidity, severe temperature
fluctuations, or strong magnetic forces (such as from speakers).
•
To use optional embroidery cards to recall embroidery patterns, connect the embroidery card
reader/USB card writer module* to this machine.
•
Store embroidery cards in their protective cases.
•
If an embroidery card other than our original embroidery cards are used, the embroidery
machine may not operate correctly. Be sure to use only recommended embroidery cards.
•
Some licensed or copyright embroidery cards cannot be used with this embroidery machine.
•
Embroidery cards sold overseas cannot be used with this embroidery machine.
•
Only insert or remove embroidery cards while an access lamp on the embroidery card
reader/USB card writer module* is not flashing, or while the embroidery machine is turned
off (refer to page 164).
* If you have purchased the Palette Ver5 or later, Palette Petite or Palette PTS, you can plug the included USB
card writer module into the machine as an embroidery card reader, and recall patterns.
Concerning USB media
•
Do not disassemble or alter the USB media.
•
Do not allow the USB media to become wet, such as with water, solvents, drinks or any other
liquids.
•
Do not use or store the USB media in a location exposed to strong static electricity or
electrical interference.
•
Do not use or store USB media in locations exposed to vibrations or impacts, direct sunlight,
extreme dust (or lint), high temperatures, high humidity, severe temperature fluctuations, or
strong magnetic forces (such as from speakers).
•
While embroidery data is being recalled from the USB media, do not allow the machine to be
exposed to vibrations or impacts, and do not attempt to remove the USB media from the machine.
•
Some USB media may not be usable with this machine. Please visit our web site
"www.babylock.com" for more details.
•
Only remove USB media while an access lamp on the USB media is not flashing (refer to
page 172).
•
For additional information, refer to the instruction manual included with the USB media that
you have purchased.
•
Do not unplug a USB device/media from this machine immediately after it has been plugged
in. Be sure to wait at least 5 seconds before unplugging the USB device/media.
152
Advertisement
Table of Contents
Troubleshooting
