Specifying Jumpstitch Trimming / "Dst" Jump Codes For Trimming - Baby Lock Enterprise BNT10L Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1 Thumbnail Background colors
2 Selected color
3 Touch
● The setting remains selected even if the
machine is turned off.
Specifying jumpstitch
trimming / "DST" jump
codes for trimming
You can specify whether or not jumpstitches are
cut. In addition, when using Tajima embroidery
data (.dst), you can specify whether or not the
thread is cut according to the specified number of
jump codes.
ON: The machine cuts the upper and bobbin
thread before the jumpstitch. When Tajima
embroidery data (.dst) is used, the machine
converts the "jump" code to a trim code, based on
the number specified on the next line.
OFF: The machine does not cut either a jumpstitch
or the "jump" code in Tajima embroidery data
(.dst).
When the machine is purchased, "ON" is selected
and the number of jumps is set to "3".
The "DST" thread trim settings can be specified
from page 2/5 of the settings screen.
● If the setting is changed from the previous
setting, the new setting is only applied to
the next embroidery.
1
2
3
to return to the settings screen.
Memo
Note
1 Touch or
setting.
The key appears as
selected, and it appears as
"OFF" is selected.
• Each touch of the key turns the setting
either on or off.
Note
● This setting is not applied to the trimming
of threads between characters in alphabet
patterns. (Refer to "Trimming the threads
between characters" on page 187.)
Memo
● The number of jump codes cannot be
specified for data other than Tajima
embroidery data (.dst).
Using the Settings Key 223
to select the desired
when "ON" is
when
6