Baby Lock Enterprise BNT10L Instruction And Reference Manual page 264

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
2 With your fingers behind the handles on the
left and right sides of the mounting jig, push
the cap frame onto the mounting jig by
pushing the handles on the left and right
sides of the cap frame with your thumbs.
1 Handle on mounting jig
2 Handle on cap frame
The cap frame is secured when the two
holders on the cap frame snap into place.
3 Release the snap lock on the cap frame by
pressing down and then disengage the latch.
Open the clamping frame. Also, open brim
holder.
1 Snap lock released
2 Clamping frame opened
3 Brim holder
262
4 Align the center of the stabilizer with the
center of the brim holder.
We recommend a stabilizer size of 100 × 510
mm (4 × 20 inches).
1 Teeth
• Make sure that the teeth go through the
stabilizer to firmly secure it.
5 Push both ends of the stabilizer into the
holes at the bottom of the cap frame to
firmly secure it.