Baby Lock Enterprise BNT10L Instruction And Reference Manual page 260

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1 Turn on the machine. After the carriage
moves to its initial position, turn off the
machine.
Note
● Be sure to adjust the cap frame driver with
the carriage at its initial position.
Using the Allen screwdriver (medium),
2
loosen the two hexagonal screws. Loosen the
screws only by about one turn.
1 Hexagonal screws
2 Allen screwdriver (medium)
Note
● Do not loosen them too far.
3 Lower the L-shaped bracket to make it touch
the machine bed and then tighten the two
hexagonal screws using the Allen
screwdriver (medium). Firmly tighten the
screws.
1 L-shaped bracket
258
4 Using the Allen screwdriver (large), loosen
the four hexagonal screws on the inside of
the ring. Loosen the screws only by about
one turn.
1 Hexagonal screws
2 Allen screwdriver (large)
When the screws are loosened, the ring
can be lowered.
Note
● Do not loosen them too far.
5 Insert the pad between the machine bed and
the ring of the cap frame driver.
1 Pad
2 Machine bed
3 Ring of the cap frame driver