Connecting The Usb Using The Included Usb Cord Clamps - Baby Lock Enterprise BNT10L Instruction And Reference Manual

SELECTING/EDITING/SAVING PATTERNS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Connecting the USB
using the included USB
cord clamps
When connecting the embroidery machine to a
computer, use the included USB cord clamps to
keep the cord away from the carriage.
Included cord clamps
Installation positions of the USB cord clamps
1 Front screw hole on the side of the machine
2 Rear screw hole on the side of the machine
1 Using the included Allen screwdriver,
remove the protective cap covering the front
screw on the side of the machine.
• Insert the end of the Allen screwdriver into
the hole in the protective cap, and then
lightly pull out the protective cap to
remove it.
170
1 2
Note
● Do not insert the Allen screwdriver too far
into the hole in the protective cap;
otherwise, the machine or the Allen
screwdriver may be damaged.
2 Open the USB cord clamp.
• With your fingernail, press on the tab to
open the clamp.
1 Tab
3 Hold the clip end of the USB cord clamp,
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
1