Avaya P333T User Manual page 26

Chapter 3 Avaya P333T Front and Back Panels
Table 3.1
LED Name
FC
Hspd
LAG
Table 3.2
Description
Left/Right
Reset module
Reset stack
FIV
Note: To perform "Force Initial Version" reset the module and at the same time
press the FIV reset button (use an opened paper clip or other pointed object).
Release the reset buttons first and 1 or 2 seconds later, release the FIV button.
Note: The Port LEDs of the P333T are numbered from 1-24. Expansion Module ports
are numbered from 51. Port LED numbers 49-50 are reserved.
10
Avaya P333T LED Descriptions
Description
Flow Control
High Speed
Link Aggregation
Group (Trunking)
Avaya P330 <- -> Select buttons
Function
Individual – select LED function (see table above).
Press both right and left buttons together for approximately two
seconds. All LEDs on module light up until buttons are
released.
Press both right and left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
Force Initial Version – boot from backup initial version of the
Avaya P330 software, from Bank A (see Note below).
LED Status
OFF – No Flow Control
ON – Symmetric/Asymmetric Flow Control
mode is enabled and port is in full duplex
mode.
10/100
OFF: 10
ON: 100
OFF – No LAG defined for this port
ON – Port belongs to a LAG
1000
N/A
1000
Avaya P333T User's Guide