Installation Of Modem Modules - Avaya IP Office 3.0 Installation Manual

Installation of Modem Modules

Either an optional Dual Modem Module or an Internal Modem Module is fitted to an IP Office base unit as
follows:
1. CAUTION - While installing, ensure that you wear a ground wrist strap that is connected to a
suitable grounding point.
2. Remove the three fixing screws on the rear of cover.
3. Turn the unit over and remove the four fixing screws from the base.
4. Slide the cover from the unit.
5. Mount the module in position as shown below and secure with the two snap-in spacers.
6. Replace the cover and secure with the seven fixing screws.
Installation Manual
IP Office 3.0 40DHB0002UKCL Issue 12c (24th February 2005)
Installing a New System
Page 47