6.8 Fitting Modem Cards
Objective - To fit and verify the presence of a modem card.
Warnings
• Correct anti-static protection steps should be taken before handling circuit boards.
• During this process power to the IP Office control unit must be switched off and disconnected.
Parts and Equipment Required
Modem Card
•
Check that the correct card has been supplied. The number and maximum capacity supported varies between
different IP Office control units. All cards are supplied with 2 plastic snap-in stand off pillars.
Modem Cards
Internal Modem Card/Modem 12
Provides 12 V.90 modem channels.
Modem 2 Card
Provides 2 V.90 modem channels.
Tools Required
Cross-head screwdriver.
•
Anti-static wrist strap and ground point.
•
IP Office Monitor application.
•
IP Office Installation
IP Office
SAP Code
IP406 V2
700343452
700185226
IP412
15-601042 Issue 20b (16 July 2009)
Page 120