Starting Ccfp Admin - Modem Connection - Avaya DECT Installation Manual

Table of Contents

Advertisement

Starting CCFP Admin - Modem Connection

DECT - Installation Manual
38HBKD0001SAH – Issue 14 (27th October 2003)
Starting CCFP Administration
1. Check that your modem is on and connected.
2. Locate and click on the CCFP Administration icon.
Windows 95/NT: Located in Start | Programs | CCFP Administration.
3. A start-up display appears. The base of the display shows the current
communications settings that will be used to connect with the DECT
system.
4. The moving bar across the display allows approximately 10 seconds to
change the communication settings (see Changing the
Communications Configuration on page 32 before it attempts to make
the connection with the DECT system.
5. A configuration display appears. It will state either:
-
Solo System Configuration Detected or
-
Master/Slave System Configuration Detected
Ensure that the correct system configuration has been selected
6. After a caution message, the main CCFP Administration screen
appears with the Status page displayed.
7. In the Modem control section, select Dial Number. Dialer Setup
appears.
Use this menu to select the DECT system you want to dial. Use
the Add and Remove buttons to create and delete entries. If you
do make any changes ensure that you select Save Database to
File to save them.
With the Company to which you want to connect displayed, click
on Dial. The Dialer Setup menu will close.
8. Watch the Receive Status display to check on the modem connection
progress.
If CONNECT appears then the modem link has been established
and you can start DECT programming by clicking on Proceed.
If CONNECT does not appear there is a problem with establishing
a modem link that must be checked. Use File | Exit to close the
program and then check the serial port, serial cable and DECT
system.
9. After clicking on Proceed the screen shows handset Registration
page. The progress indicator at the top-right of the screen shows the
progress in copying down the DECT system's settings.
Using Windows CCFP Administration - Page 33
Starting CCFP Admin - Modem Connection
Page 33

Advertisement

Table of Contents
loading

Table of Contents