08. Fitting Modem Cards - Avaya 4600 Series Installation Manual

Procedure: Installing VCM Cards
Installation Manual
IP Office 3.2
1. Check that correct card has been
supplied.
2. Ensure that you are wearing an anti-static
wrist strap connected to a suitable
ground point.
2. Remove the 7 screws fixing the IP Office
control unit cover and slide the cover off
the control unit.
3. Locate the position for the card and its
jumper block.
4. Using the card as a template locate the
two holes in the control unit circuit board.
Insert the spacer pegs into these holes.
5. Using minimal force and checking that
the pins are correctly located, push the
card onto the jumper block and spacer
pegs.
6. If other cards are being fitted, proceed to

08. Fitting Modem Cards.

7. Slide the control unit cover back on and
replace the cover screws.
8. Reapply power to the control unit and
check that it restarts correctly.
9. Using the IP Office Monitor application,
confirm that the correct number of voice
compression channels are reported. They
are shown by the value VCOMP= at the
start of the Monitor trace.
15-601042 Issue 14b (13th November 2007)
A. Basic Installation
Page 89