Configuring The H323Sp Board; Configuring Virtual Board Hmcp; Virtual Board Hmcp - Altigen MAXCS ACC 6.5 Administration Manual

The number of configured channels and licensed channels are displayed.
AltiServ is set by default to support 60 SIP extension channels. You can change the
number of SIP extension channels and tie-trunk channels. The maximum number
possible depends of the system CPU performance, call volume, and usage. If a high
performance machine is used as the Softswitch server, the number of channels can be
more than 1000. If you change the numbers in this dialog box, you must shut down and
restart the switching and gateway services for this change to take effect. When the
services restart, the new configuration appears in the Currently Configured Channels
fields.
The SIP Trunking Configuration button opens the SIP Trunking Configuration dialog
box. (See "SIP Trunk Properties" on page 159.)

Configuring the H323SP Board

Double-clicking an H323SP board in Boards view and then clicking the Board
Configuration button opens this dialog box:
Figure 18. H323 Configuration
You can change the following parameters:
FastStart Enabled: The FastStart Enabled option reduces the number of H.323
•
messages to be sent between two H.323 devices when initiating a call, thus reducing
the time needed to establish a call. There may be a compatibility issue with firewall
or NAT devices, if you select this option.
Max Tie-Trunk Channel: Sets the maximum number of trunk channels for this
•
board in increments of 4, from 4 to 96. You need to reboot the MAXCS system after
the maximum trunk channel number is changed.

Configuring Virtual Board HMCP

This section is for a Multi-Gateway Softswitch with an HMCP media server installation
only. A single all-in-one system does not require configuration of this board.
Host Media Control Processing (HMCP) is a virtual board that uses an Intel CPU to provide
the following functions:
1. Process VoIP Media Stream
Encode, decode, and transcode voice stream
•
Detect and generate tone for IP devices
•
If you change the
maximum number of
trunk channels, you need
to reboot the MAXCS
system.
MAXCS ACC 6.5 Administration Manual 141
Chapter 11: Board Configuration