Table of Contents
Advertisement
5. At the secondary system, install MAXCS 6.5 software. The virtual board types
(H323SP, SIPSP, and/or HMCP), must mirror the virtual board types installed on the
primary system.
6. Set up the Dataprobe K-AB system. Make sure the IP address of the primary,
secondary and K-AB system are static.
Configuration Procedures
Configure the primary and secondary servers, as follows.
At the Primary Server
1. Install the Redundancy license.
2. Configure primary system boards, and reboot if necessary.
3. Set configurations to the primary system, such as extensions, trunks, VoIP dialing
tables, and so on.
4. Select System > Redundancy to open the Redundancy dialog box.
Figure 2. Redundancy dialog box
a.
Select Primary as the system role.
b.
Check the Enable Redundancy check box.
c.
Enter IP addresses for the primary and secondary servers and the AB-Switch.
d.
Enter a redundancy key (your password for redundancy; it needs to be the same
for primary and secondary systems).
e.
Enter the shared Softswitch IP address.
5. Click OK or Apply when finished.
At the Secondary Server
1. Power on the secondary system.
2. Install the Redundancy license.
Chapter 26: Redundancy Configuration
MAXCS ACC 6.5 Administration Manual 367
Advertisement
Table of Contents
Troubleshooting
