Changing The Enterprise Manager Password - Altigen MAXCS ACC 6.5 Administration Manual

Click a tab to view or configure settings on that tab. Information on a tab is related to
the selected server. Click buttons in the toolbar to perform configuration tasks. Click a
column heading to sort by that column.
Configuration Buttons
Servers button displays the VoIP domain name, servers in the system, and server
•
ID length. Lets you add/remove servers and change the VoIP domain master. Lets
you re-route outgoing calls of global extensions and redirect AltiGen IP phones.
Displays the configuration and informational tabs listed in the next section.
Codec button lets you configure individual codec profiles—silence suppression,
•
codec, jitter buffer range, RTP packet length, DTMF delivery, enable/disable SIP
early media, and SIP transport.
User button displays information about extensions in the VoIP domain and lets you
•
change an extension to global or local and relocate an extension.
Department button lets you define departments in the VoIP domain and assign
•
extensions to departments.
Global LCR button lets you add E.164 number patterns and specify source and
•
target sites.
Tabs Displayed with the Servers Button
Information tab displays information about the selected site and lets you configure
•
a PSTN number for global extension rerouting as a failover when the TCP/IP network
is down. You may also assign an alternate server to which to redirect global AltiGen
IP phones when their primary server is down.
IP Networks tab defines IP networks and the bandwidth information for an MAXCS
•
site. Bandwidth usage control for Internet and intranet can be set up here. If the
bandwidth usage exceeds the maximum setting, the call will not be established.
IP Dialing Table tab defines the IP dialing table for an MAXCS site. Specified
•
information here includes a codec profile and a protocol (SIP or H323) for the
communication from this site to the selected site.
IP Codec tab lets you specify an inter-gateway codec and define IP device ranges
•
to which you can assign a codec profile.
Number Plan tab displays the number plan information that is set up in MaxAdmin,
•
System Configuration window, Number Plan tab.

Changing the Enterprise Manager Password

Only a person with DomainAdmin rights can change the Enterprise Manager password.
To change the password, click the Password button at the top of the Enterprise
Manager window. The following dialog box opens:
Chapter 25: Enterprise VoIP Network Management
MAXCS ACC 6.5 Administration Manual 329