HP NonStop SQL/MX Messages Manual page 496

Utility Messages (20000 through 23099)
SQL 20072
20072 First character of the field delimiter must be
different than the first character of the row delimiter.
Cause. The field delimiter and row delimiter strings that you specified, either at the
command line or in the DELIMITED FORMAT section of the format file, start with the
same character. When only one of them is specified at the command line, the value for
the other delimiter is either the default value, as specified in the IMPORT topic of the
SQL/MX Reference Manual, or the value specified in the DELIMITED FORMAT section
of the format file.
Effect. The operation fails.
Recovery. Specify a row delimiter and field delimiter that start with a different
character and resubmit. If you specify only one at the command line, it should not start
with the same character as the other delimiter.
SQL 20073
20073 Object objname does not exist.
Where objname is the ANSI name of the target table.
Cause. The object name that you specified was invalid or does not exist.
Effect. The operation fails.
Recovery. Specify a valid object name. Verify that the catalog name, schema name,
and table name sections of the ANSI name are specified.
SQL 20074
20074 IMPORT cannot open datafile - file name.
Where file name is the input data file name.
Cause. SQL was unable to open the data file that you specified either because it was
missing or because of some other file system problem. The input file might be corrupt
or, if it resides on a remote system, the remote system password is not set.
Effect. The operation fails.
Recovery. Check the validity of the input file. If the input file is a valid remote file,
verify that the remote password for the system is set.
HP NonStop SQL/MX Messages Manual—640324-001
18 -20