HP NonStop SQL/MX Messages Manual page 286

Executor Messages (8000 through 8999)
SQL 8842
8842 The cursor, name, referenced by this statement is not
found or is not updatable.
Where name is the name of the cursor.
Cause. There is an error in the program that this code is embedded in. The build
might not have completed successfully.
Effect. The operation fails.
Recovery. Verify that the build was successful and resubmit.
SQL 8843
8843 Trying to retrieve an item, value, that is out of range.
Where value is the entry number of the item.
Cause. The item number of the requested descriptor item or the item number of the
descriptor item being set is out of range. The value must be less than the maximum
number of occurrences specified when the descriptor area was allocated.
Effect. The operation fails.
Recovery. Specify a valid number between 1 and the maximum allocated item count
of the descriptor.
SQL 8844
8844 A transaction started by SQL that was committed or
aborted by user application from outside of SQL, has now been
cleaned up.
Cause. After NonStop SQL/MX started a transaction that was committed or aborted by
an embedded program, rather than from NonStop SQL/MX, you used SQL COMMIT or
ROLLBACKWORK to properly finish the transaction.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
SQL 8845
8845 An internal error occurred: root_tcb is null.
Cause. This is an internal error.
Effect. The operation fails.
HP NonStop SQL/MX Messages Manual—640324-001
10 -38