HP NonStop SQL/MX Messages Manual page 122

SQL/MX MXCMP Messages (2000 through 2999)
Recovery. This is an informational message. To prevent this warning, turn off query
caching before query preparation.
SQL 2200
2200 DEFAULTS attribute attribute is read-only.
Where attribute is the DEFAULTS attribute.
Cause. You attempted to change the DEFAULTS attribute, which is read-only.
Effect. The operation fails.
Recovery. None.
SQL 2201
2201 SQL compilation return code is mxcmp non-zero exit code.
Cause. You invoked mxCompileUserModule on an application file that has an
embedded module definition. An SQL compilation of an embedded module definition
resulted in an MXCMP nonzero exit code, indicating a warning or error.
Effect. The operation fails.
Recovery. Review the MXCMP warning or error message. Trace the diagnostic back
to the module source file and correct the offending source statement. Retry
preprocessing, translating, compiling, and SQL compiling the application file.
SQL 2202
2202 Application file is not an application (ELF or SQL)
file.
Cause. You invoked mxCompileUserModule on an application file that is not a
NonStop Open System Services (OSS) ELF object file.
Effect. The operation fails.
Recovery. Verify that the name application file is an ELF object file. Verify that
the name of application file is spelled correctly, and retry the command.
SQL 2203
2203 Application file application pathname cannot be opened.
Cause. You invoked mxCompileUserModule (or mxcmp -a application pathname
mdf) on an application that does not exist or is inaccessible to the user.
HP NonStop SQL/MX Messages Manual—640324-001
4- 26