HP NonStop SQL/MX Messages Manual page 441

MXCI Messages (15000 through 15999)
SQL 15397
15397 DS name can not be *.
the command.
Cause. The data source in the command is an asterisk (*).
Effect. The operation fails.
Recovery. Enter the command again, specifying the data source name. An INFO DS
command will list known data source names.
SQL 15398
15398 Could not get attribute info for DS "string0" from
database.
Where string1 is the data source name.
Cause. A failure occurs in the client library.
Effect. The operation fails.
Recovery. See the lower-level error messages below this message.
SQL 15399
15399 Invalid DS name in COPY option, starts with '$' or
backslash without quotes.
or service name here. The old and new DS must reside on the
same system and service.
Cause. An invalid data source name is entered.
Effect. The operation fails.
Recovery. Enter the command specifying a valid data source file name.
SQL 15400
15400 No service active for tracing.
Cause. No services are available to activate tracing for this DS.
Effect. The trace operation is not processed. If this failure occurs during execution of
an ADD DS command, it is possible the DS is successfully created in either the
database or on a service before the service is terminated.
Recovery. If the error occurs during execution of ADD DS, run INFO DS to verify that
the DS is successfully created. Then run INFO SERVICE to list known services. If the
HP NonStop SQL/MX Messages Manual—640324-001
+++SUGG: Specify a DS name on
+++SUGG: Do not specify a system
15 -53