HP NonStop SQL/MX Messages Manual page 107

SQL/MX MXCMP Messages (2000 through 2999)
SQL 2037
2037 receiving process: A message from process sending
process was incorrectly formatted and could not be processed.
Cause. The NonStop SQL/MX process receiving process received a message
from process sending process that was unreadable in some way. Either the
message was corrupted by sending process, or an internal error occurred within
receiving process.
Effect. The SQL/MX statement fails.
Recovery. None. Contact your service provider.
SQL 2038
2038 Character set name is not supported for SQLCI attribute
TERMINAL_CHARSET.
Where name is the name of the character set.
Cause. You specified a non-ISO88591 character set name.
Effect. The operation fails.
Recovery. Specify an ISO88591 character set name.
SQL 2050
2050 attribute is not the name of any DEFAULTS table
attribute.
Where attribute is the attribute name you specified.
Cause. If the SQLSTATE is 42000, this is an error. You attempted to set a CONTROL
QUERY DEFAULT setting, but the attribute name you specified is not valid.
If the SQLSTATE is 01000, this is a warning. In an earlier SQL/MX session, you
inserted a row into a DEFAULTS table whose attribute column value is invalid.
Effect. If this is an error, the operation fails. If this is a warning, this is an informational
message.
Recovery. Correct the attribute name and resubmit.
HP NonStop SQL/MX Messages Manual—640324-001
4- 11