HP NonStop SQL/MX Messages Manual page 486

Utility Messages (20000 through 23099)
SQL 20030
20030 The specified start key cannot be HIGH_VALUES.
Cause. You specified a start key as HIGH_VALUES, which is not supported.
Effect. The operation fails.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20031
20031 The specified end key cannot be LOW_VALUES.
Cause. You specified an end key as LOW_VALUES, which is not supported.
Effect. The operation fails.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20032
20032 An internal problem was detected.
Cause. SQL detected an internal error.
Effect. SQL is unable to process the statement.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20033
20033 The partition must be empty before you drop it.
Cause. You attempted to drop a nonemtpy range partition.
Effect. The operation fails.
Recovery. Make sure the range partition is empty before dropping it.
SQL 20034
20034 Catalog does not exist or has not been registered on
the local node.
Cause. The catalog is not visible on the local node, either because it does not exist or
because it exists elsewhere in the network and has not been registered on the local
node. This utility message corresponds to message 1002.
Effect. The operation fails.
HP NonStop SQL/MX Messages Manual—640324-001
18 -10