HP NonStop SQL/MX Messages Manual page 393

MXCI Messages (15000 through 15999)
Recovery. Correct the syntax and resubmit.
SQL 15018
15018 Break was received.
Cause. You pressed Break to stop processing of your most recent MXCI command.
Effect. The last statement might be lost.
Recovery. Informational message only; no corrective action is needed.
SQL 15019
15019 value values were supplied in the USING list while the
statement contains value unnamed parameters.
Cause. You specified an EXECUTE command with a USING clause whose value
number of parameters do not match the value number of unnamed parameters.
NonStop SQL/MX requires these values to match.
Effect. The operation fails.
Recovery. Correct the syntax and resubmit.
SQL 15020
15020 The USING list must contain at least one parameter
value.
Cause. You specified an EXECUTE command with a USING clause, but you did not
specify parameter values. NonStop SQL/MX requires at least one parameter value.
Effect. The operation fails.
Recovery. Correct the syntax and resubmit.
SQL 15021
15021 The USING list cannot contain more than value parameter
values.
Cause. You specified an EXECUTE command with a USING clause that has more
parameter values than are supported.
Effect. The operation fails.
Recovery. Correct the syntax and resubmit.
HP NonStop SQL/MX Messages Manual—640324-001
The last statement may be lost.
15- 5