HP NonStop SQL/MX Messages Manual page 428

MXCI Messages (15000 through 15999)
SQL 15332
15332 USAGE: FILE option is supported only with TCFG. TMACL
displays to the screen.
Cause. You entered the command string version service, tmacl, file xxx:
MACL trace does not support the file option. Instead, the command output goes to the
screen, and you cannot specify these two attributes together.
Effect. The operation fails.
Recovery. Enter the command without the file option. For example, enter the
command string version service, tcfg:.
SQL 15350
15350 Stop request failed for SERVER process process-name on
SERVICE service-name, object reference was server-name.
Where process-name is the name of the process.
Where service-name is the name of the service.
Where the server-name is the name of the server.
Cause. The server process fails to stop the service. A possible problem might exist in
passing messages to the server.
Effect. The operation fails.
Recovery. See lower-level error messages issued with this message. Also see
information about this error in the EMS collector for MXCS service event messages,
which is specified on the mxoas start command with $0 as the default.
SQL 15351
15351 SERVER name must be * if DS selection attribute is
specified.
Cause. Server name is other than an asterisk (*) wild card to specify the DS selection
attribute.
Effect. The operation fails.
Recovery. Run the INFO SERVER command using the asterisk (*) wild card for the
server name when specifying the DS attribute.
HP NonStop SQL/MX Messages Manual—640324-001
15 -40