Advertisement
!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!!;
iiiiiiiiiiiiiiiiii!
iiiiiiiiiiiiiiiiii
ififififififififififififififififii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i
iiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiil
iiiiiiiiiiiiiiiii_i
iiiiiiiiiiiiiiiiiii Just like changing the o[1 in your ear or re@acing a filter in your home's heating and cooling system, a little preventive maintenance
iiiiiiiiiiiiiiiiii
will [nsureyourtreadm[ll
will operatesmooth[yandqu[et[yforyearstoeome.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!
_
iiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii:
As walking belts tend to stretch slightly with use, the walking belt may occasionally need to
be tightened•
If the walking belt is too loose, you may find the belt stops while running or
walking, while the motor continues to run. DO NOT OVERNGHTENTHE BELT•This will cause
reduced motor performance and can cause roller damage. When properly tensioned, you
should be able to lift the side of the belt about 2-3 inches (5-7 centimeters).
A quick test for
belt tension: you should be able to fit three fingers under the edge of the belt.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii:i
iiiiiiiiiiiiiiiiil U se the hex key provided with the treadmill(or
a 3/!6 inch hex wrench). Place the hex key in
the hole in left end cap and into the socket of the adjustment screw. Turn key one full turn
clockwise. Then place hex key in hole in right end cap and turn key one full turn clockwise.
Cheek the tension of the belt. Continue back and forth until belt is at the correct
tension. Make sure to adjust both sides equally to ensure correct belt alignment.
WALKING
BI!LiY CI}•NTERING
The walking belt may occasionally need to be centered.
First be certain that belt is tensioned properly (see above).
Run the treadmill at about 3.5 mph (6 kph).
Place the hex key through the hole in the left end cap and into the socket of the adjustment
If belt hss moved
to the Aght:'
Turn the right adjustment screw 1/2 turn clockwise, then
turn the left adjustment screw !/2 turn counterclockwise.
If belt does not move, repeat until belt is centered.
1/2 TURNS
UNTIL BELT iS CENTERED
THEN RECHECK TENSION
OF THE BELT
If the belt as
moved /o t'se /eft:
Turn the right adjustment screw !/2 turn counterclock-
wise, then turn the left adjustment screw !/2 turn
clockwise. If belt does not move, repeat until belt is cen-
tered.
1/2 TURNS
UNTIL BELT iS CENTERED
THEN RECHECK
TENSION OF THE BELT
Then recheck tension of the belt (see above).
Advertisement
