Starting The Pilot - FireplaceXtrordinair 44 DV XXL EF Manual

3 8
Starting The Pilot Flame
The pilot flame is required to ignite the main
burners (it also plays a safety role). It should be left
on once lit. It will stay lit unless the gas control
valve is turned to "OFF". However, the pilot will go
out if the gas is shut off, the propane tank runs out
(or low) or if the stove malfunctions. If the pilot
turns off frequently, call your dealer for information.
To start the pilot follow the directions below:
WARNING :
When lighting or re-lighting the pilot,
the glass must be removed (see page
2 9 ) .
a Remove the glass (see page 29 for details).
b Push the gas control knob in slightly and turn it to
the "OFF" position. The knob will not turn from
"ON" to "OFF" unless the knob is depressed
slightly. Wait five minutes to let any gas that may
have accumulated inside the firebox escape. If
you smell leaking gas, follow the directions on
the cover "IF YOU SMELL GAS".
c Turn the gas control knob to the "PILOT"
position and press the knob in, this will allow gas
to flow to the pilot light. Press the button on the
pilot igniter repeatedly until you see the pilot
light.
WARNING:
If the pilot does not light after 15
seconds, release the knob and call your
dealer for service.
light pilot until service has been
performed.
N O T E :
You may wish to remove the log set to
gain a better view of the pilot (see page
3 1 ) .
d Keep the gas control knob depressed for 30
seconds once it is lit.
e Release the gas control knob. If the pilot goes
out, repeat step C. If the pilot refuses to stay lit,
call your dealer for service. With the pilot lit,
proceed to step "f".
f Replace the glass.
g Turn the gas control knob counter-clockwise to
"ON". The pilot is now lit and the heater can be
turned on and off.
Travis Industries
Operation
Do not attempt to
4050114
a
b
c
d
e
f
g
5 minutes
PILOT
IGNITER
30 seconds
?
1 0 0 - 0 1 1 4 9