Operation; Before You Begin; Location Of Controls - FireplaceXtrordinair 44 DV XXL EF Manual

Before You Begin

Warning: Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass
should be done by a licensed or qualified service person.
Location of Controls - See explanation below
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The indicator line is
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off Switch "OFF"
will keep the fireplace off always.
Travis Industries

Operation

The pilot flame is located
below the rear log.
Gas
Control
Valve
Flame Adjust Knob
Gas Control Knob
This knob controls the speed of the internal convection blower that pushes the
heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an electrical
charge to the pilot assembly. This creates a blue spark directly next to the pilot,
igniting the pilot flame.
This knob controls gas to the burner and pilot. There are three positions: ON, OFF,
and PILOT. The indicator line is to the left of the knob.
above the knob.
Open the
access door to
view the
controls.
IGNITER
ON
OFF
On/Off Switch
Pilot Igniter
4050114
OFF
HI
LO
Blower Knob
1 0 0 - 0 1 1 4 9
3 7