Finalizing The Installation; Glass Removal (& Installation) - FireplaceXtrordinair 44 DV XXL EF Manual

Finalizing the Installation

1 Remove the glass (and arch covers) following the directions below.
Warning: The appliance must be completely cool before removing the glass.
Warning: To prevent damage, do not abuse, strike, or slam the glass shut.
Note: Attach the arch covers after re-installing the glass.
Open the six latches holding the glass
a
frame in place (start with the bottom
three) - follow the directions shown to
the right.
Glass Frame
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions to the right in reverse).
c) Lift the glass frame slightly and attach the lower latches.
Arch Covers (both sides)
Arch Cover
Glass
Travis Industries
NOTE:
You may need to lift
the glass frame
while re-attaching.
The arch covers (included
in the owner's pack) block
Glass
light from exiting the scroll
Frame
work on arched faces.
The covers hang on the
glass frame.
Arch Faces:
Attach arch covers before
installing the face.
Rectangular Faces:
Discard the arch covers.
4050114
(for qualified installers only)
Spring Pin
Top of
Firebox
Glass
Latch Bracket
2 9
Insert the 1/4" key
into the spring
pin.
Twist 1/4 turn.
The spring pin will
disengage from the
latch bracket,
opening the latch.
1 0 0 - 0 1 1 4 9