Starting The Pilot Flame - FireplaceXtrordinair 36DV-AR Owner's Manual

Starting The Pilot Flame

The pilot flame is required to ignite the main burners (it also plays a safety role). It should be
left on once lit. It will stay lit unless the gas control valve is turned to "OFF". However, the
pilot will go out if the gas is shut off or if the stove malfunctions. If the pilot turns off
frequently, call your dealer for information. To start the pilot follow the directions below:
NOTE: IF YOU'RE TRYING TO RE-LIGHT THE PILOT BECAUSE SERVICE WAS
PERFORMED ON THE UNIT (I.E. GAS LINE REMOVED THEN RE-INSTALLED OR
BECAUSE TANK RAN OUT OF GAS), FOLLOW THE INSTRUCTIONS FOR REMOVING
THE GLASS AND LOGS ON PAGES 24 THROUGH 25 THEN BLEED THE GAS LINE.
A Push the gas control knob in
slightly and turn it to the
"OFF" position. The knob
will not turn from "ON" to
"OFF" unless the knob is
depressed slightly.
B Wait five minutes to let any
gas that may have
accumulated inside the
firebox escape. If you smell
gas, follow the directions on
the cover "IF YOU SMELL
GAS".
C Turn the gas control knob to
the "PILOT" position and
press the knob in, this will
allow gas to flow to the pilot
light. Press the red button
on the pilot igniter
repeatedly until you see the
pilot light. KEEP THE GAS
CONTROL KNOB
DEPRESSED FOR 30
SECONDS ONCE IT IS
LIT. NOTE: IF THE
PILOT DOES NOT
LIGHT AFTER 15
SECONDS, RELEASE
THE KNOB AND CALL
YOUR DEALER FOR
SERVICE.
D Release the gas control
knob. If the pilot goes out,
repeat step C. If the pilot
refuses to stay lit, call your
dealer for service.
E Turn the gas control knob
counter-clockwise to "ON".
The pilot is now lit and the
stove can be turned on and
off.
A
PILOT ADJ
C
PILOT ADJ
PILOT ADJ
D
PILOT ADJ
O (C
PERATION
B
5 minutes
Do not press knob in for more than
15 seconds if pilot does not light.
Call Your Dealer For Service
PILOT
IGNITER
E
?
)
ONTINUED
P
AGE
30 seconds
PILOT ADJ
29