Dhd Controller Rear Panel - Runco Signature Cinema SC-50d Series Installation & Operation Manual

7. RIGHT BUTTON
Used to direct-select inputs or move the OSD menu cursor to the right. When no
menus are present on-screen, the RIGHT button toggles through the different
sources, in this order:
Composite 1 - Composite 2 - Composite 3 - Component - HD 1 - HD 2 - SCART -
HDMI 1 - HDMI 2 - HDMI 3 - HDMI 4
8. MENU BUTTON
Press the MENU button to bring up the main menu, or to exit the current menu and
return to the previous one.
9. UP BUTTON
Use to direct-select aspect ratios or move the OSD menu cursor up. When no menus
are present on-screen, the UP button toggles through aspect ratios in the following
order:
Native - Virtual Cinema - Cinema - VirtualWide - Letterbox - 4:3 - 16:9
10. ENTER BUTTON
When an item is highlighted on the OSD, the ENTER button selects the item.
11. STANDBY LED
Lights amber when the DHD Controller is in standby mode; otherwise it is off.
Figure 2-4 shows the rear connector panel on the DHD Controller.
1
7
Figure 2-4. DHD Controller Rear Panel
1. MAIN POWER SWITCH
Disconnects or applies power to the DHD Controller.
2. TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
3. USB
A standard, USB Series "B" connection to a personal computer, for performing
software upgrades and other service procedures.
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
Downloaded From projector-manual.com Runco Manuals
Y Y Y Pb Pb Pb Pr Pr Pr
G G B B R R H H V V
Y Y Pb Pb Pr Pr H H H V V V
G G B B R R
8
2 3 4
TRIGGERS
USB RS-232
1 2 3
To Accessory Box
Component / SCART Componen p en nt / SCART
HDMI 1 HDMI 3
Video 1 Video 1 Video 2 Video 2
Pb Pb Pr Pr Video 3 Video 3
HDMI 2 HDMI 2 HDMI 2 HDMI 4 HDMI 4 HDMI 4
9 10 11
9
Controls and Functions
2.4
DHD Controller Rear
Panel
5 6
Display Control
IR
HDMI Out
To Display
RS-232
PC / Control
HDMI Out
Ethernet
Audio Only
12 13 14 15