Preparing The Cables; Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 6: Installing Summit Family Switches

Preparing the Cables

A ring terminal and two spade terminals are provided with the power supply. You need a crimping tool
to attach the terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal
terminal securely to the wire.
Figure 211: Attaching Terminals to Cables
Power connection wire

Installing the Power Supply

CAUTION
The handle on the Summit X650 DC power supply is not designed to be used to lift or carry the Summit
X650 series switch.
To install an 850 W DC power supply in a Summit X650 series switch:
1 If necessary, remove a blank panel from the back of the Summit X650 series switch
Figure 212: Removing a Blank Panel
262
Ground wire
SH_109
SH_106
Summit Family Switches Hardware Installation Guide
(Figure 211) and crimp the
(Figure 212).
SH_110