Connecting Active Or Passive Qsfp+ Cables; Connecting Console Ports For A Stack - Extreme Networks Summit X150 Series Hardware Installation Manual

Connecting Active or Passive QSFP+ Cables

The QSFP+ direct-attach cable is used to connect ports on either of the following modules:
SummitStack-V80 stacking module installed in a Summit X460 series switch
●
VIM2-SummitStack-V80 module installed in a Summit X480 series switch
●
To connect a QSFP+ direct-attach cable:
1 Holding the QSFP+ connector by its sides, insert the connector into the port on the switch
(Figure 155).
Figure 155: Connecting a QSFP+ Direct-Attach Cable to a SummitStack-V80 Module
Passive copper cable
2 Push the connector into the port until you hear it click into place.

Connecting Console Ports for a Stack

To begin the software configuration for a new stack, you must have at least one console port connected.
Connect a console to the console port of the switch that you intend to become the master of the stack. If
you are going to configure redundancy, you may wish to connect to the console ports of all switches in
the stack that you will configure to be master-capable. If you followed the cabling examples in
"Connecting the Switches to Form the Stack Ring" on page
configuration procedure, only slots 1 and 2 will be allowed to become master.
Summit Family Switches Hardware Installation Guide
Connecting Console Ports for a Stack
SH_193
Active optical cable
184, and you use the easy-setup
SH_195
209