Panasonic KX-VC500 Operating Manual page 111

Message
Connection will be closed in
n seconds.
Press "YES" to continue.
Note
•
The message first
appears when one
minute remains and
"60" is displayed for
n. Then, the
remaining time starts
to decrease.
Disconnected.
Call failed due to insufficient
bandwidth setting on called
site.
Feature is not available with
current connection.
Document Version 2011-02
•
The time set for "Call Limit time" has one minute remaining
(Page 78).
→
If you select "Yes", you can extend the call limit time for the amount
set for "Call Limit time".
If you select "No", the call is disconnected.
•
When connecting to an MCU or non-Panasonic video conference
system, the video conference call was disconnected because
encryption settings were enabled.
→
Disable encryption settings on both sides.
•
When connecting to an MCU or non-Panasonic video conference
system, the video conference call was disconnected for an unknown
reason.
→
Wait a while and then try making the video conference call again. If
video conference calls get disconnected repeatedly, contact your
dealer.
•
The other party's maximum bandwidth is set to a value that cannot
support 3-party/4-party video conference calls.
→
Ask the other party to change their maximum bandwidth setting.
•
The other party cannot display the computer's screen because their
display does not support the selected resolution.
→
Change the resolution setting to a resolution that is supported by the
other party.
→
Contact your network administrator.
•
Tone signals could not be sent because the other party's device does
not support tone signals.
→
Ask the other party to check their configuration.
Cause and Solution
Additional Information
Operating Manual 111