Windows NT 4.0 Configuration
Preparing to Use the NetBEUI Protocol for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
Configuring the Printer
2
Configure your printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information on how to make the above settings, refer to the Operat-
ing Instructions for your printer.
Configuring a Windows NT Computer
Install the NetBEUI protocol into a Windows NT computer, and enter the LAN
adapter number (Lana Number).
A
Double-click the [Network] icon in the [Control Panel], and confirm that "Net-
BEUI Protocol" is in the [Network protocols] box of the [Protocols] tab.
Note
If the NetBEUI protocol is not installed, click [Add] in the [Protocols] tab,
and install it. For more information, refer to the Windows NT online help.
B
Change the Lana Number. Click the [Services] tab, select the [NetBIOS inter-
face] of the [Network Services] box , and click [Properties].
C
Select the Lana Number corresponding [Nbf protocol] of the [Network route]
headline, and click [Edit].
D
Input "0" as the Lana Number.
Note
If the other protocol's Lana Number is configured with "0", you must
change the Lana Number a number other than "0".
E
Click [OK].
F
Click [close], and close the [Network] dialog.
G
After confirming the message for restart, click [Yes].
Note
When you change the Lana Number, You must restart.
18