Ricoh Afico 180 Copy Reference Manual page 299

Appendix
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol
appletalk
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web
5
Note
If you prohibit remote access using TCP/IP and then logout, you cannot use
remote access. If this was a mistake, you can use the printer operation panel
to allow access by TCP/IP.
When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp, rsh, diprint, and web.
Status of Printer
The following commands can be used to get information about the current status
of the printer.
msh> command
Command
status
info
prnlog [ID]
netstat
Note
More information on the print job is displayed when the ID number is added
after the prnlog command.
64
"Up" means active and "Down"
means inactive.
Information that is displayed
Status of printer.
Information about the print job.
Information about the paper tray, output
tray, emulation and program of printer.
Lists the last 10 print jobs.
Information on the Network Interface
Board.