Mixing Scan Settings In A Multiple - Ricoh Afico 180 Copy Reference Manual

ty yourself, use Manual Image Densi-
ty.
Auto Image Density
The machine automatically selects an
image density which is the most ap-
propriate for the original.
By default, Auto Image Density is se-
lected when the machine is turned on
or modes are cleared. You can change
this with the User Parameters.
P.184 "Changing the User Parameters"
A
If the Auto Image Density indica-
tor is not lit, press the l
turn it on.
Manual Image Density
Use the Image Density keys to vary
the image density within 7 levels.
A
Make sure that the Auto Image
Density indicator is not lit. If it is
lit press the l l key to turn it off. l l
B
Press the i i or j i i
the density. The indicators above
the keys show the level.
l key to
l l
j key to change j j
Mixing Scan Settings in a
Multiple Page Original
When sending an original consisting
of several pages, you can select differ-
ent Image Density, Resolution and
Original Types for each page.
Set your original, select the scan set-
tings for the first page, dial and press
{Start} as you would normally. Then
follow one of the following two pro-
cedures.
When Setting Originals on the Exposure
Glass
While the machine is bleeping, you
have about 60 seconds (10 for Imme-
diate Transmission) to select density,
resolution and original type. The re-
maining time is shown on the display.
A
Check the pages you wish to
change the setting.
B
Remove the previous page and set
the next page.
C
Select the Image Density, Resolu-
tion and Original type.
Note
You adjust settings for each
page before you press the
{Start} key.
SCAN SETTINGS
2
37