Ip Address Setting - Kyocera KM-1650 Advanced Operation Manual

IP Address Setting

ADVANCED OPERATION GUIDE
Use the following procedure to register an IP Address to the machine.
Check with your network administrator before performing this procedure.
If you use the following procedure to register the IP Address manually,
ensure DHCP is Off and TCP/IP is On.
NOTE:
Any changes made to network settings become valid after you
power the machine off and on again.
1
Display the TCP/IP screen, refer to TCP/IP, on page 2-14.
2 Press or to select Change #
and press [Enter].
3
Press or to select IP
Address and press [Enter].
4
Press or to select IP
Address and press [Enter].
5 Use the keypad to enter the
address. Enter the first segment
of the IP Address in the
highlighted area and press [#].
6
Enter the next segment and press
[#].
Enter the remaining segments
using the same procedure.
Press [Enter] when the entire address has been entered.
Printer Settings
TCP/IP
On
Off
Change #
TCP/IP Setting
Back
DHCP
IP Address
TCP/IP Setting
Back
DHCP
IP Address
IP Address
0 . 0 .
IP Address
10 . 0 .
0 . 0
0 . 0
2-15