Interface - Kyocera KM-1650 Advanced Operation Manual

Interface

Access the Interface Screen
Parallel Interface
ADVANCED OPERATION GUIDE
This machine is equipped with a parallel, USB and network interface as
standard.
The following settings are available:
• Parallel Interface
• Network Setting
• IP Address Setting
• Subnet Mask Setting
• Default Gateway
• Network Status Page Printing
1
Press [Printer].
2 Press or
and press [Enter].
3
Press or
and press [Enter].
Setup the options required.
The parallel interface supports bi-directional/high-speed mode. The
transmission/reception modes that can be set are shown below.
Mode
Auto The printer automatically changes its communication mode
according to the connected computer. We recommend you
leave this setting unchanged.
Normal The printer uses the standard communication method
prescribed for Centronics interfaces.
High speed This mode enables faster data transmission between the
printer and the computer. Select this mode if printing
problems occur when the printer is connected to a
workstation.
to select MENU
Ready
to select Interface
Menu
Description
Printer Settings
GO
CANCEL
MENU
Back
Print Status Page

Interface

2-11