Resolving Ip Address - Kyocera EcoPro EP C170N User Manual

Resolving IP Address

ADVANCED OPERATION GUIDE
6 Press . One of the following menus is indicated. To change settings for
the item, press [OK] ([ENTER]). Use
selection.
Set this item to On when you connect to a
network using NetWare. In submenu (>),
frame mode can be selected from Auto,
802.3, Ethernet-II, and 802.2.
Set this item to On when you connect to a
network using TCP/IP. Submenu (>) has
items including DHCP, BOOTP, IP
address, subnet mask address, and
gateway address. To resolve IP address
for the network card, see Resolving IP
Address on page 2-33.
Appletalk must be activated (On) for
networking with Macintosh computers.
When the item is set to On, the printer
prints out a network status page when it
prints the printer status. See Printing a
Network Interface Status Page on page
2-35.
7 Activate the appropriate protocol that is required to connect the printer to
the network. To activate a protocol, display the protocol, press [OK]
([ENTER]), press
([ENTER]).
8
Press [MENU]. The display returns to Ready. You can print a network
status page to confirm that the IP address, subnet mask address, and the
gateway address have been properly set. To print a network status page,
see Printing a Network Interface Status Page on page 2-35.
To connect the printer to the network using TCP/IP protocol, you must set
the IP address on the printer. The IP address must be unique to the printer
and should be obtained from your network administrator.
1
Activate TCP/IP protocol in the manner
described above.
or
or to change from Off to On, and press [OK]
Using the Operator Panel
to change the value or
>NetWare
On
>TCP/IP
On
>Appletalk
Off
>Network Status
Page Off
>TCP/IP
On
>
>
>
2-33