Resetting The Printer - Epson EPL-N2000 Reference Manual

Using the printer driver:
Change the Density setting on the Printer SelecType menu in
the printer driver.
Using the Remote Control Panel utility:
Bring up the Remote Control Panel utility by typing EPRCPO
at the DOS prompt; select the appropriate emulation from the
main Remote Control Panel window; click the Printer Setup
button; then change the Density setting.
Using the SelecType mode:
For information on using SelecType, see Chapter 5.
Note:
Increasing the print density increases toner consumption. If you select
darker print, you may need to replace the Imaging Cartridge more
often.

Resetting the Printer

There are two ways to reset (return to a fixed set of conditions)
the printer.
Reset
Reset the settings for the emulation mode and interface you are
using now by holding down ALT and Reset until
appears on the display. You can reset the printer anytime a
printout is not being sent on the interface you are using.
Reset all
Reset the settings for all emulation modes and interfaces by
holding down ALT and Reset until appears on the
display. You can also reset all emulation modes and interfaces
by turning off and turning on the printer.
Note:
Reset all clears all print jobs received from all interfaces, so be careful
not to disrupt someone else's print job.
6-34
Troubleshooting and Maintenance