Epson Gl/2 Mode - Epson EPL-N2000 Reference Manual

EPSON GL/2 Mode

Note:
You cannot change the GL/2 Mode items by SelecType. To change
these items, use the GL/2 command listed in Appendix C.
In EPSON GL/2 mode, you can use your printer with plotter
applications. EPSON GL/2 has two operational modes. One is
the LJ4GL2 mode; the other is the GLlike mode. The GLlike
mode emulates some of the HP-GL plotter commands and
includes all of the commands found in LJ4GL2 mode, plus two
additional commands.
The table below shows the differences between these modes.
For more information on GL/2 commands in LJ4 emulation
mode, see Appendix C.
Command
Orientation
Plotter unit
Picture frame
Default position of P1
and P2
Undefined
commands
CS, CA commands
PG, AF commands
Results when a DT
command with no
second parameter is
sent
ESC %#A commands
5-28
SelecType
LJ4GL2 mode
Printer setting
1/1016 inch
Same as LaserJet 4
mode
Lower left and
lower right corners,
respectively, of
picture frame
First character is
ignored
Not supported
Not supported
Terminator is not
plotted
Supported
GLlike mode
Landscape only
1/1021 inch
Depends on the
hard-clip limit
inside of picture frame
First two characters
are ignored
Partially supported
Supported
Terminator is plotted
Not supported