If you want to eliminate the top margin and print at the very top of
the page, adjust the loading position so that the top of the paper lines
up with the raised line on the ribbon mask, as shown below.
After you set the load ing p osition, p ress the Pa use bu tton to
5.
tu rn off m icro-ad ju st m od e.
For both single-sheet and continu ou s p ap er, you r load ing p osition
setting rem ains in effect u ntil you change it, even if you tu rn off
the p rinter.
Adjusting the printing position
The p rinting p osition is the p osition on the p age w here the p rint
head actu ally p rints d u ring a p rint job. You can change the cu rrent
vertical p rinting p osition tem p orarily by u sing the m icro-ad ju st
featu re as d escribed in the step s below .
Not e:
Y our printing position setting is in effect only until the next time you
load paper or turn off the printer.
1.
Make su re that the p rinter is not p rinting. If it is, p ress the
Pa use bu tton to stop p rinting.
ra ised line
Paper Handling
3
3-29