Sony Handycam NEX-VG20 Operating Manual page 17

When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
Charging time
Approximate time (rain.) required when you fully charge a fully discharged battery pack.
NP-FV70 (supplied) 195
NP-FV100 390
• The cbarging times shown in the table above are measured when charging the camcorder at a
temperature of 2._ C (//°F). It is recommended tbat you cbarge the battery in a temperature range of
10 °C to 30 °C (50 °F to 86 °F).
OTips
• See page 66 on recoMing and playing time.
• When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
Slide the POWER switch to OFF. Slide the BATT (battery) release lever ((!)) and remove the
battery pack (@).
5 ¸
BATT (battery) release lever
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 3: Charging the battery pack" (p. 16). Even if the battery
pack is attached, the battery pack is not discharged.
_7