Load The Setting Values Stored In The Storage Area To The Work Area - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
GS ( M
p p fn m
L H
[Name]

Load the setting values stored in the storage area to the work area

[Format] ASCII
Hex
Decimal
p p
[Range] ( +
L
TM-J2000/J2100, TM-T90,
[Description] Loads the command setting values stored in the storage area specified by
• When
• When
[Notes]
This function is effective at the beginning of a line in standard mode.
This function cannot be included in a macro. Do not use this function when executing a macro.
The value in the work area is set to the default value by the following:
• Executing this function by specifying
• Executing Function 2 with the condition that the storage area that has not executed Function 1 is
• Initializing when an autoload process has been canceled by Function 3.
The values in the work area that are not affected by this command are not changed.
The values in the storage area are not changed.
The values affected by this command are different, depending on the printer models. See model-
dependent variations for details.
Paper roll Customize commands
<Function 2>
GS ( M p p
L
02 00 fn m
1D 28 4D
2 0
29 40 77
× 256) = 2, (
p p
= 2,
H L H
TM-L90,
m
= 0, 48, the default values described in this guide are applied.
≠ 0, 48, the setting values are stored in the storage area specified by
m
specified.
GS ( M
fn m
H
fn m
fn
= 0), = 2, 50
TM-P60: m = 0,1, 48, 49
m
= 0, 48.
m
to the work area.
m
.
Ver. 10.01 p. 632