Feed Paper To The Cutting Position - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
FS ( L <Function 66 >
[Name]

Feed paper to the cutting position

[Format] ASCII
Hex
Decimal
p p
[Range] ( +
L
m = 48, 49
fn
= 66
[Description] Feeds paper to the cutting position.
m
48
49
[Notes]
Please use this function by using "the first state of the line" in standard mode.
This function is used when using "black mark paper."
The paper feed operation ends when no paper is detected in the paper feed to the cutting position.
[Position information A] transmitted by Function 48 becomes (bit 1 = 1) when this function is used.
Moreover, the print area of the label paper or black mark paper if there is a print start position right under
the cutting position becomes "current label."
Paper roll Printing paper commands
FS ( L p p
L H
1C 28 4C 02 00
28 40 76 2 0
× 256) = 2 (
p p
= 2, = 0)
H L H
Function
Feeds paper to the cutting position. However, if the paper is in standby at the
cutting position, the printer does not feed.
Feeds paper to the cutting position. However, if the paper is in standby at the
cutting position, the printer feeds paper to the next cutting position.
fn m
m
42
m
66
FS ( L Ver. 10.01 p. 655