Esc C 4 - Epson TM-T88III Programming Manual

C O N F I D E N T I A L

ESC c 4

[Name] Select paper sensor(s) to stop printing
[Format] ASCII
Hex
Decimal
0 ≤ ≤ 255
[Range] n
n
[Default] = 0
[Printers not featuring this command]
[Description] Selects the paper sensor(s) to use to stop printing when a paper end is detected using
n:
Bit Off/On
0
1
2
3
4-7
[Notes]
It is possible to select multiple sensors to stop printing. When any sensor detects a paper-end, printing
stops.
Some sensors are not present, depending on the printer model.
The names of some sensors differ, depending on the printer model.
The roll paper near-end sensor is enabled when either bit 0 or bit 1 is on or both are on.
Paper roll Paper sensor commands
Paper sensor commands
n
ESC c 4
n
1B 63 34
n
27 99 52
TM-P60
Hex Decimal
Off 00 0
On 01 1
Off 00 0
On 02 2
Off 00 0
On 02 4
Off 00 0
On 08 8
— — —
ESC c 4
Function
Roll paper near-end sensor disabled.
Roll paper near-end sensor enabled.
Roll paper near-end sensor disabled.
Roll paper near-end sensor enabled.
Roll paper end sensor disabled.
Roll paper end sensor enabled.
Roll paper end sensor disabled.
Roll paper end sensor enabled.
Undefined.
S
ETTING COMMAND
n
as follows:
... how to use
this table
Ver. 10.01 p. 163