Set User Setup Commands - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
GS ( E
[Name]

Set user setup commands

[Printers not featuring this command] TM-T88III, TM-L60II, TM-U230, TM-U210,
[Description] Controls the user setting modes. The table below explains the functions available in this command.
• Function code
fn
Function No. Function name
1 Function 1
2 Function 2
3 Function 3
4 Function 4
5 Function 5
6 Function 6
7 Function 7
8 Function 8
9 Function 9
10 Function 10
11 Function 11
12 Function 12
48 Function 48
49 Function 49
50 Function 50
•
Paper roll Customize commands
Customize commands
fn
specifies the function.
Change into the user setting mode.
End the user setting mode session.
Change the memory switch.
Transmit the settings of the memory switch.
Set the customized setting values.
Transmit the customized setting values.
Copy the user-defined page.
Define the data (column format) for the character code page.
Define the data (raster format) for the character code page.
Delete the data for the character code page.
Set the communication item for the serial interface.
Transmit the communication item for the serial interface.
Delete the paper layout
Set the paper layout
Transmit the paper layout information
× 256) as the number of bytes after
p , p specifies ( p + p
L H L H
[parameters]
Description of the
GS ( E
is described in each function.
E
TM-U300A/B
p ( fn and [parameters]
H
Ver. 10.01 p. 570
+ S
XECUTING ETTING
).