Qr Code: Print The Symbol Data In The Symbol Storage Area - Epson TM-T88III Programming Manual

C O N F I D E N T I A L
GS ( k <Function 181>
[Name]

QR Code: Print the symbol data in the symbol storage area

[Format] ASCII
Hex
Decimal
p p
[Range] ( +
L
cn
= 49
fn
= 81
m
= 48
[Description] Encodes and prints the QR Code symbol data in the symbol storage area using the process of <Function 180>.
[Notes]
In standard mode, use this function when printer is "at the beginning of a line," or "there is no data in the
print buffer."
The symbol size that exceeds the print area cannot be printed.
If there is any error described below in the data of the symbol storage area, it cannot be printed.
• There is no data (Function 180 is not processed).
• If the data of the symbol storage area is more than the data allowed by specified model and data
• The four data compaction modes are listed below (in order of compaction rate). Automatically selects
The following data are added automatically by the encode processing.
• Position Detection Patterns
• Separators for Position Detection Patterns
• Timing Patterns
Paper roll Two-dimension code commands
p p
GS ( k
L
1D 28 6B 03 00 31
3 0
29 40 107
× 256) = 3 ( = 0)
p p
= 3,
H L H
compaction mode. (This case is an abnormal number of data.)
best compaction mode by the data of the symbol storage area.
– Numerical mode
– Alphanumeric mode
– Kanji mode
– 8-Bit Byte Mode
cn fn m
H
51 m
49 81 m
GS ( k Ver. 10.01 p. 535