Trap Settings; Status Notification Setting - Konica Minolta bizhub C452 Network Administrator's Manual

2.41 Reporting the status of this machine (TRAP)
Item
IPX Setting
Ethernet Frame
Type
2.41.3

TRAP Settings

In the administrator mode of PageScope Web Connection, select "Network" ö "SNMP Setting".
Item
Allow Setting
Trap Setting when
Authentication
Fails
2.41.4

Status Notification Setting

In the administrator mode of PageScope Web Connection, select "Maintenance" ö "Status Notification
Setting" ö "IP (IPX) Address" ö [Edit].
Item
Notification ad-
dress
Port Number
Node Address
Community Name
Replenish Paper
Tray
JAM
PM Call
Replace Staples
Replenish Toner
Finisher Tray Full
Service Call
Job Finished
Hole-Punch Scrap
Box Full
Waste Toner Box
Full
Imaging Unit Yield
Fusing Unit Yield
Transfer Roller Unit
Yield
Transfer Belt Unit
Yield
bizhub C652/C652DS/C552/C552DS/C452
Description
Select "ON".
Select a frame type to be used.
Description
Select "Allow".
Select whether to enable TRAP transmission at the time of
authentication failure.
Description
If the destination has an "IP address", enter it. If the DNS
server has already been configured, you can enter the
host name instead."If IPv6" is set to "ON", you can also
specify the IPv6 address.
If the destination has an "IPX address", enter it using an 8-
digit hexadecimal value.
If the destination has an "IP address", enter its port
number.
If the destination has an "IPX address", enter the node ad-
dress using a 12-digit hexadecimal value.
Enter a community name (up to 15 characters).
Sends a notification when the paper tray is empty.
Sends a notification when a page has been jammed.
Sends a notification when the periodical inspection is re-
quired.
Sends a notification when there are no staples remaining.
Sends a notification when the toner is empty.
Sends a notification when the capacity of the finisher tray
has been exceeded.
Sends a notification when a service call has occurred.
Sends a notification when the job has finished.
Sends a notification when you need to empty the punch
scrap box.
Sends a notification when the waste toner box needs to be
replaced.
Sends a notification when the imaging unit (IU) needs to
be replaced.
Sends a notification when the fusing unit needs to be re-
placed.
Sends a notification when the transfer roller unit needs to
be replaced.
Sends a notification when the transfer belt needs to be re-
placed.
2
Prior check
Frame type
Prior check
Prior check
Notification address
2-123