Table of Contents
Advertisement
Chapter 2:
Getting to Know the GERBER MAXX 2
The GERBER MAXX 2 is a sophisticated machine but is very easy to use. The following pages
introduce the printer and describe basic operation.
Basic requirements
The MAXX 2 is a network device. Your computer must have an Ethernet network card installed
to communicate with the printer. Gerber provides the proper network cables to connect your
computer with the MAXX 2 so that you are up and running without delay.
You must have OMEGA 1.56 or higher to print to a MAXX 2. However, you do not have to
specifically design a job for the MAXX 2.
We currently support the Gerber ODYSSEY plotter and the Gerber FasTrack 1300 plotter for
cutting MAXX 2 graphics.
Environment and temperature importance
The room temperature where the MAXX 2 is located should be 68°F to 78°F (20°C to 25.6°C)
with a relative humidity of 20% to 85%. Be sure to allow the equipment and materials to reach
and remain at room temperature for 24 hours before printing.
Using MAXX READY material
The MAXX prints only on GERBER MAXX READY materials. Gerber specially developed
GERBER MAXX READY materials for thermal printing and are the only materials
recommended for use with the MAXX. Gerber continues to qualify more substrates and foils on
an on-going basis. For a list of currently qualified MAXX READY materials see www.gspinc.com.
Gerber recommends printing on only 36" MAXX READY material. Do not use punched vinyl,
material less than 36" in width, or any other material that is not MAXX-qualified. Residue from
the punched vinyl adhesive can cause serious problems that will require service.
Vinyl care
CAUTION: Never clean vinyl with isopropyl alcohol, only clean the vinyl with
distilled water.
The best way to keep the vinyl clean is to always use the material catching baskets. If the vinyl
gets dirty (often the static charge on the vinyl attracts dirt from the rug or floor), the printed job
may show imperfections such as voids, hair lines, or small unprinted areas. Wipe the vinyl with
a clean, lint-free cloth moistened with distilled water. Allow the vinyl to dry completely before
3
Advertisement
Table of Contents
