Table of Contents
Advertisement
Message
Paused by Operator
Press CANCEL to exit
Press ENTER if "yes",
CANCEL if "no"
Press ENTER to clear
error and exit
Press Run To Retry
Preparing Image Data
Printhead not detected
Printing...
Ready for Print Job
Some data for this foil
may be wrong
Unload Any Bay to
Proceed
Unload Cassette From
Bay
Unprinted Jobs Found in
Queue
Version P.p D.d B.b
Vinyl Not Properly
Loaded
X-axis Failure
Y-axis Failure
Z-axis Failure
Type
Comment/Action
I
Appears if you press RUN or STOP once while printing.
P/A
Appears after you press the function key for < Error(s) Detected.
Pressing CANCEL exits the error display screen but does not clear the
error message.
P/A
This is a general prompt to confirm an action.
P/A
Appears after you press the function key for < Error(s) Detected.
Pressing ENTER clears the error message and exits the display
screen. If the message continues, call Gerber Field Service.
P/A
Press if there is any axis failure.
I
Displayed while the MAXX 2 is preparing data for the next print
swipe.
I
Call Gerber Field Service.
A job is printing.
I
Appears when the MAXX 2 is idle and ready to print.
I
Problem with cassette. Call Gerber Field Service.
P/A
Appears if all bays have cassettes and there is also a cassette loaded
on the printhead carriage.
P/A
A cassette has been loaded in a bay from which the printhead
carriage took a cassette.
I
Displayed at power up if unprinted jobs are in the job queue.
I
Displays power up or when looking at the About Printer submenu.
P.p = PC program version
D.d = DSP program version
B.b = firmware build number
P/A
Vinyl is not properly loaded. Left edge should be aligned with guide
mark, vinyl must be under magnet bars and between the keeper
plates. Reload the vinyl.
P/A
May display at power up when X-axis does not initialize properly.
Check for obstruction and press RUN to attempt to reset the failure.
P/A
May display at power up when Y-axis does not initialize properly.
Check for obstruction and press RUN to attempt to reset the failure.
P/A
May display at power up when Z-axis does not initialize properly.
Check for obstruction and press RUN to attempt to reset the failure.
45
Advertisement
Table of Contents
